Specifications

Page 18

ZONESENSE PLUS

OPERATION & PROGRAMMING

Fire Fan

The sub menu consists of;

Alarm

Inhibit

Function

Latch

ACF Isolate

For:

Alarm

Inhibit

Press Enter then use the Move Right and / or Move Left keys to select the Fire Fan that

will be controlled by the selected functions in the sub - menu .

Press Enter to access the sub – menu then Move Right and /or Move Left keys to

toggle through the sub - menu structure. Press Enter then Move Right and /or Move Left

keys to select the Zone/s that will activate or deactivate the control when it is in alarm or

inhibited. Use the Move Up or Move Down keys to set it to active or in-active. Active

meaning the Zone will operate the control where as in–active will prevent that Zone from

having control.

For:

Function

Press Enter and the cursor will flash over the number 0,1 or 2, then press the Move Up or

Move Down keys to select the required Function. Selection relies on how the inputs /

outputs have been physically wired from the Fan Termination Board as outlined below.

0: equates to a 3 wire Start / Stop, Run & Common.

1: equates to a 4 wire Start / Stop, Run, Stop & Common.

2: equates to a 5 wire Start / Stop, Run, Stop, Fault & Common.

FUNCTION 2

Press Enter to update the Program and then Cancel to back out of the Menu.

For:

Latch

ACF Isolate

Press Enter and the cursor will flash over YES or NO and then the Move Up key for Yes to

set the card to be latching or Move Down key for No to set the card for non-latching on

alarm.

Press Enter to update the Program and Cancel to back out of the Menu.

FAN 2

ALARM

2..................

INHIBIT

3................

LATCHING

YES

LATCHING