Specifications

Page 17
ZONESENSE PLUS OPERATION & PROGRAMMING
Set the Reset / Buzzer output option so as the output acts as a Reset or Buzzer function as
per the system design configuration.
Screen Showing the Output Set to Reset
If the output is used set as a Reset or Buzzer function by using the Move Up for Buzzer or
Move Down keys for Reset. Press Enter to update the program
Relays
Press Enter then use the Move Right and / or Move Left keys to select a relay that will
be operated by the selected functions in the sub - menu . Press Enter to access the sub –
menu then Move Right and /or Move Left keys to toggle through the sub - menu
structure. The sub menu consists off;
Zone
Alarm
Zone
Fault
Zone
Isolate
Input
Switch
Reset
ACF
Isolate
For:
Zone
Alarm
Zone
Fault
Zone
Isolate
Input
Switch
Press Enter then Move Right and /or Move Left keys to select the Zone Alarm / Fault /
Isolate, Input or Switch then Enter. Use the Move Right and / or Move Left keys to
select the Zones and the Move Up or Move Down keys to set it to be active or in-active.
Active meaning the Zone Alarm / Fault / Isolate, Input or Switch will operate the Relay where
as in–active will prevent them from operating that relay.
Press Enter to update the Program and the Cancel to back out to the previous menu.
For:
Reset
ACF Isolate
Press Enter then the Move Right and /or Move Left keys to select Reset or ACF Isolate
then the Move Up or Move Down keys to set for Yes or No.
Yes sets the Relays to be reset or isolated when the Reset and / or ACF Isolate buttons are
pressed.
Press Enter to update the Program and Cancel to back out to the previous Menu.
RST / BZ
RESET
RELAY 3
R3 Z . ALM
1...3...5...7
R2 SWIT
...3...5...7
R3 ACFIS
NO
R2 LATCH
YES
R5 RESET
NO