Specifications

Page 37
FIREFINDER SERIES II INSTALLATION, COMMISSIONING &
OPERATION
Select  (Selecting  presents the PROGRAMMING MENU) then  or 
(as seen below) then ENTER to ADD the module or device to the configuration, or skip to resolve the
changes manually in the Programming Menu.
0: ADD EXTRA MODULES 1: ADD EXTRA DEVICES
2: DEVICE TYPE MISMATCH 3: MODE MISMATCH
SELECT NO:
Figure 50: Resolving Extra Modules or Devices
8.8.10 Mismatch Detected
If a mismatch is detected the Normal Default Screen will change to that shown below. Go to the
Programming Menu and select either  Resolve Extra Modules and Devices then 
(Device Type) or  (Mode) to resolve the mismatch, OR On Site Programming to resolve manually.
L1 S6 Z1 STAT: TYPE MISMATCH
ZONE FAULTS 1 OF 1
Loop 1 Sensor 1
Figure 51: Resolving a Mismatch