Specifications

Page 34
FIREFINDER SERIES II INSTALLATION, COMMISSIONING &
OPERATION
8.8 Function Programming
Press
 To display the Level III Programming Menu.
ON SITE PROGRAMMING MENU
0: CONV ZONE 1: DEVICE 2: INPUT 3: OUTPUT
4: PANEL BASED MCP 5: SUB ADDRESS 6: WDOG
SELECT NO.
Figure 43: Programming Menu
8.8.1 Conventional Zone Programming
Press
 Zone:
Key in the zone number and enter or change the description (DESC) by pressing
buttons to move the flashing underline or curser. The numeric buttons multiple times to access
characters while at the same time using
EDIT Zx DESC AND TYPE SETTING
DESC < ZONE >
TYPE <
ALPHA KEYS ARE ACTIVE
Figure 44: Zone Description & Type Programming
EDIT Z CONFIGURATION
CONFIG LATCHING
use < or > to change alarm setting
Figure 45: Brigade Options
Press to move to the TYPE field or edit the information.
Press to move between fields use the reciprocal button
By going through all the fields a second screen can also be accessed to show the Output options.
Press to step through these fields.
The keys are used to set the Y/N field, that is the selected Zone that will activate the
Brigade Options ALRM, BELL etc and Config.
EDIT Z I/O GROUPS
GROUP 1: GROUP 2: GROUP 3:
GROUP 4: GROUP 5: GROUP 6:
Enter GROUP NO:
Figure 46: Zone Configuration Latching / Unlatching
Use or to change the setting
Configuration settings are Latching, Non-Latching, AVF, Self Reset (0 to 99 seconds). After setting
the Configuration the ZONE I/O GROUPS are programmed.
ENTER Zx BRIGADE OPTIONS AND CONFIG
ALRM: Y/N BELL: Y/N AUX: Y/N SPK: Y/N AIF: Y/N
ALARM LED: Y/N CONFIG: LATCHING
use < or > to change setting
Figure 47: Zone I/O Groups