Specifications
Page 32
FIREFINDER SERIES II INSTALLATION, COMMISSIONING &
OPERATION
8.6 Function Manual I/O Control
Press
To display the Manual I/O Control menu
MANUAL I/O CONTROL
0: INPUT 1: OUTPUT
2: REMOVE MANUAL CONTROL
SELECT NO.
Figure 41: The Manual I/O Control Menu
Manual I/O control allows the technician to turn ON or Off inputs and outputs off a device to facilitate
testing or isolation of plant during maintenance. Removal of manual control returns control to the
panel.
Press
Input Selected:
Press
IN A PANEL: Enter the I/O Controller number then the input number. This will display the
description for the input and its current state; you can then turn the input ON or OFF or remove
manual control.
ON A LOOP: Enter the loop number, the sensor number and the input number. This will display
the description for the input and its current state; you can then turn the input ON or OFF or remove
manual control.
Remove All Manual Input Control: Will remove all manual input control.
Output Selected: Same sequences as above for inputs but substitute outputs for inputs.
Remove All Manual Control Selected: Globally removes all manual control.
8.7 Function Access (Level II) / Passwords (Level III)
Press
While in the Main Functions menu and enter the Level III Password if in Access Level II or, if in
Access Level III to display the Password Menu.
FUNCTIONS
PASSWORD
select PASSWORD then ENTER key
PASSWORD MENU
0: ADD PASSWORD 1: DELETE PASSWORD
2: DELETE ALL PASSWORDS 3: SENSOR MODE
SELECT NO.
Figure 42: The Level II Password Entry & Level III Password Menu Screens
Add Password: Enter the new password, then press ENTER. The password is always a 4 digit
number.
Delete Password: Enter the password that you want to delete, and then press ENTER.
Delete All Passwords: This asks you to confirm that you want to delete all the passwords.
Press ENTER then ENTER again.
Zone / Sensor Mode: This sets the mode in which Alarms, Faults, Pre-alarms and Isolates
status information will be displayed. “Zone” is the default setting.