Specifications

Page 30
FIREFINDER SERIES II INSTALLATION, COMMISSIONING &
OPERATION
8 Main Functions
LEVEL II MAIN FUNCTIONS
0: DATE 1: TIME 2: DAYNIGHT SETTINGS 3: LOGS
4: TESTS 5: I/O 6: ACCESS
SELECT NO:
LEVEL III MAIN FUNCTIONS
0: DATE 1: TIME 2: DAYNIGHT SETTINGS 3: LOGS
4: TESTS 5: I/O 6: PASSWORDS
SELECT NO:
Figure 39: The Level II & III Functions Menu
8.1 Setting the Function Date Facility
Select FUNCTION. A prompt will ask for a PASSWORD if the control panel is not currently active.
Using the keypad key in the Level 2 or 3 PASSWORD and press ENTER.
Press
 To select the set DATE SCREEN. The prompt will ask for the date to be entered in this format,
DD/MM/YYYY (e.g. 01/01/2011), key in and press ENTER. The screen will then return to the MAIN
FUNCTIONS MENU.
8.2 Setting the Function Time Facility
Press
 Then in the following format key in the time, HH:MM (e.g. 16:00) using the 24 hour mode. Press
ENTER and the screen will return to the MAIN FUNCTIONS MENU.
8.3 Setting the Function Daynight Facility
Press
 The DAY-NIGHT SETTINGS screen will appear. Time entry is the same as setting the “Time”
facility
Press
 To enter the DAY ON time then ENTER and,
 To enter the NIGHT ON time then ENTER.
 To ENABLE / DISABLE then ENTER.
For this Function to have control it must be ENABLED, press  Re-pressing  will toggle to
DISABLE.
8.4 Function Logs Facility
Press
 And the EVENT LOG MENU will be displayed.
The LOGS MENU allows the operator to select and view the events that have occurred of all;
Press:  ALARM,  FAULT,  ISOLATE,  SYSTEM
EVENT LOG MENU ( MAXIMUM SIZE = 1162 )
0: ALARM 1: FAULT 2: ISOLATE 3: SYSTEM
4: I/O
SELECT NO:
FAULT LOG 7/7 11/7/2005 14:56 05
SUPPLY FAULT
ST: EARTH FAULT
SELECT 0: PRINT ENTRY 1: SHOW OPTIONS
Figure 40: Logs Function Menu & Fault Log Selected
Once the type of log is selected, e.g. FAULT above, each entry can be viewed by stepping through
them using the
NEXT
and
PREVIOUS
keys