Specifications

Page 77
FIREFINDER SERIES II CONFIG MANAGER SESSION 6
Once the panels are all in diagnostic mode proceed as below.
Send the new config to the panel to which you are connected using your communication package file
transfer as you would normally:
It is important to take note of the output during programming and make sure that no errors are
reported.
Once this is done the host panel has been programmed with the latest configuration.
Send the configuration around the network using the NSC (Network Send Configuration) command:
NSC
When you enter the NSC command the “Sending Panel Config” dialogue will appear and the offset
will increase in value until it reaches the Config Size.
At this point the “Down Load Complete” message will appear as well as file received confirmations
for each controller on the network. It is important that you receive one of these messages from each
controller (except the one that you are programming from) on the system before proceeding to the
next step.
Program the panels around the network using the NPC (Network Program Configuration) command: