Specifications

Page 67

EN54 FIREFINDER PLUS INSTALLATION,COMMISSIONING & OPERATION

12.13.6 SmartTerminal Controls and Indicators

All controls, except for the controls Enable / Disable Keyswitch, are of a momentary push button

style and operate in exactly the same way as does the FACP itself.

Figure 94: SmartTerminal Front Panel Layout

12.13.7 SmartTerminal Screen Format

There are 3 events that can be reported and displayed by SmartTerminal. The types of event are;

 Fire

 Faults and

 Disables.

The types of events are only associated with devices and detectors hence faults associated with

modules, loops O/C – S/C, power supplies and so forth are not reported on the LCD.

The SmartTerminal has front panel indicators for each type of event. When SmartTerminal is

configured not to report a type of event and that event type is present (and the corresponding front

panel indicator is illuminated on the SmartTerminal), then a standard information screen is

displayed on the LCD stating the system is not normal and the operator should see the FACP.

Alarm: If configured the screen format for reporting loop / device / zone fire condition is:

<point location> FIRE

FIRE XXX OF XXX

Fault: If configured the screen format for reporting loop / device / zone fault condition is:

<point location> FAULT

FIRE XXX OF XXX

Note: The fault types only relate to devices.

In the event of a loss of communications, for a period of greater than 15 seconds the SmartTerminal

will default to the No Communications screen. The format for this screen is: