Specifications

Page 1
EN54 FIREFINDER PLUS INSTALLATION,COMMISSIONING & OPERATION
1 About This Manual
1.1 Introduction
This manual contains all the information required to install, commission and operate the FireFinder
PLUS Fire Alarm Control Panel (FACP) and is only available to and for the use of personnel
engaged in its installation, commissioning and operation.
1.2 General Requirements
The FireFinder PLUS FACP has been designed and manufactured from high quality commercial
components so as to comply with major world standards. To ensure these standards are not
compromised in any way installation staff and operators should;
 Be qualified and trained for the task they undertake;
 Be familiar with the contents of this manual prior to the installation, commissioning or
operation of a FireFinder PLUS control system;
 Observe anti-static pre-cautions at all times; and
 Be aware that if a problem is encountered or there is any doubt with respect to the
operational parameters of the installation the supplier should be contacted.
1.3 References
ConfigManager: Operation Manual
Apollo: Detector / Device Manuals
Ampac: Product Data Sheets
British Standard:
BS 5839.1-2008: Fire Detection and Fire Alarm systems for buildings
European Standard:
EN54.2-1998: Fire Detection and Fire Alarm Systems. Control and Indicating Equipment
EN54.4-1998: Fire Detection and Fire Alarm Systems. Power Supply Equipment
1.4 Symbols
 Important operational information
Note: Configuration considerations
Observe antistatic precautions
Mains supply earth
DANGER mains supply present