Specifications

Page 48
EN54 FIREFINDER PLUS INSTALLATION,COMMISSIONING & OPERATION
8.8.10 Mismatch Detected
If a mismatch is detected the Normal Default Screen will change to that shown below. Go to the
Programming Menu and select either  Resolve Extra Modules and Devices then 
(Device Type) or  (Mode) to resolve the mismatch, OR On Site Programming to resolve manually.
Loop 1 Sensor 1
L1 S6 Z1 STAT: TYPE MISMATCH
ZONE FAULTS 1 of 1
Figure 70: Resolving a Mismatch
Self Learn is enabled / disabled in the EEPROM programming. If enabled FireFinder PLUS has the
ability to detect extra or missing modules or devices, (that is devices or modules that have been
added or removed) or there has been a change of the type of module or device.
Note: If a change does occur the FACP will take 30seconds to register the event on the LCD
and illuminate the FAULT LED.