Specifications

Ampac Technologies Pty Ltd

FireFinder

Operators Manual

PAGE 29

DOC No:G0109WO1.doc DIR: L:\MANUALS DATE: 30/11/00 REVISION: 3

7.6 The Main Menu

Fig 23:The Main Menu

From the main menu the user is able to view any Acknowledged alarms on the system. You can also

view any pre-alarms, faults or isolates on the system. If there are no alarms, faults or isolated zones or

devices, a message will display for about a second and the display will then return to the previous menu.

7.6.1 Status Menu

Fig 24: The Status Menu

Press 4 while on the Main Menu to display the Status Menu.

From the status menu you can interrogate the status of all of the system components and settings listed

below

0. Loops: Enter the loop number and it will display its status.

1. Modules: Enter the module number and it will display the type, the software version and its status.

2. Supply: This will display the charger voltage, whether or not the power supply is in fault, and if the

battery is correctly fitted.

3. Brigade: This will display the status of all of the brigade relays and outputs on the brigade board.

4. I/O: Can display the status of the input output in a panel or on a loop. You must enter the I/O module

number, then the input or output on that module (or the loop and sensor number and the output on

that device) it will then give you a description of what that input or output does and tells you its

current state.

5. Network: Display the status of the network.

6. System: This will display the status of the system. eg Faults, Alarms, Isolates.

7. A values: This will display the analog value being returned by a detector. It will display the

description of the detector, as well as its type, its state and the Raw Analog Value in counts.

STATUS MENU

0: LOOPS 1: MODULES 2: P/SUPPLY 3: BRIGADE

4: I/O 5: NETWORK 6: SYSTEM 7: AVALUES

SELECT No.

MAIN MENU

0: ALARMS 1: PREALARMS 2: FAULTS

3: ISOLATES 4: STATUS 5: TESTING

SELECT No.