Specifications

Ampac Technologies Pty Ltd

FireFinder

Operators Manual

PAGE 28

DOC No:G0109WO1.doc DIR: L:\MANUALS DATE: 30/11/00 REVISION: 3

7.3 Incoming Alarm Signal

Will flash common alarm indicator

• Will display location of alarm origin on the LCD

• Will activate the external bell.

• Will activate the internal FIP buzzer. (optional)

• Will activate any ancillary equipment so programmed.

• Will abort any test in progress.

The LCD will display the first alarm signal received. The LCD will also display other essential alarm

information and operator prompts. The LCD back light is normally off until operator intervention. An

active alarm signal must be acknowledged before any other condition can be imposed on it.

7.4 Accessing a Loop, Sensor or Zone

LOOP OR SENSOR

1. From the Keyboard, press LOOP

2. Enter the loop number you wish to interrogate then press SENSOR.

3. Press the key for the sensor number.

4. Press the TO key if you wish to access a range of sensors on the loop, the DISPLAY key if you

wish to display the status if a sensor, the ISOLATE key if you wish to isolate a sensor, or the DE-

ISOLATE key to de-isolate a sensor.

ZONE

1. From the Keypad, press ZONE

2. Press the key for the zone number.

3. Press the TO key if you wish to access a range of zones, the DISPLAY key if you wish to display

the status of a zone, the ISOLATE key if you wish to isolate a zone, or the DE-ISOLATE key to

de-isolate a zone.

7.5 Accessing Functions and Menus

From the default display, press FUNCTION, which brings up the

display for entering a password giving access to the panel's functions.

Or press MENU to bring up the main menu.

(See quick reference guide)

Screen prompts will guide you through the menu operations.

FUNCTION