Specifications

FIREFINDER NZ CONFIGURATION MANAGER
13 Help Commands
The following lists of commands are dependent upon the software version of the panel as not all of
the commands are supported prior to Version 6.
In the normal running mode of the panel there are several help commands that are available if
required. By typing “he” and pressing enter, the following list of commands will appear.
13.1 Application Mode Help Commands (he)
bf n
deactivate the brigade outputs
bi n
isolate the brigade outputs
bo n
activate the brigade outputs
Where n=3(bell), n=4(plant), n=5(evac), n=6(fault), n=7(alarm), n=8(isol), n=9(batt),
n=10(valve monitor)
bm
buzzer mute
bt
go boot
gd
go diagnostics
qv
query version
wb
warm boot
13.2 Advanced Application Mode Help Commands (hea)
bu 0
disable fault buzzer
ef 0
disable earth fault
bu 1
enable fault buzzer
ef 1
enable earth fault
da
node address and cont no.
fi
flash identify
db 0
disable all debug
li
log information
db 1
enable sensors updates
qc
query configuration
db 2
enable module updates
qp
query points
db 3
enable loop updates
sa
dbase offsets for the modules
db 4
enable received network packets
sb
show status of the mailboxes
db 5
enable network sent packets
sl
status of loop
db 6
enable nic packets
sm
status of module
dc
display config table
sp
status of the panel
dd
display ddcmp statisics
ss
status of sensor
dl
display application limits
vr
read charger voltage
dm
display memory
vs
set charger voltage
du
display utility table
wb
warm boot
ed
display eeprom
13.3 Network Commands available (hen)
nbm
network buzzer mute
nga
network go application
nbu 0
network disable fault buzzer
npc
network program configuration
nbu 1
network enable fault buzzer
npa
network program application
nef 0
network disable earth fault
nsc
network send configuration
nef 1
network enable earth fault
nsa
network send application
ngd
network go diagnostics
nwb
network warm boot
13.4 Boot Mode (he) (hea) (hen)
Commands available
da
read address switch
pa
program application
dm
display memory
qv
query version
ed
display eeprom
fi
flash id
ee
erase eeprom
fe
flash erase
ep
program eeprom
bs
boot stop
ei
erase eeprom
cn
connect to nic
gd
go diagnostics