Specifications

FIREFINDER NZ CONFIGURATION MANAGER
4.6.6 Edit Internal Serial
Click on the “Tab” Internal Serial and the Edit screen will be displayed.
Type: Click within the box to access the drop down screen and select the type of board, in the
example shown a Relay Board has been selected.
Output: Double click within a box to edit the type of input that will turn the output on.
In the example screen a Relay Board has been assigned
 O/P 1 has been set to be turned on by an Alarm Assigned Point.
 O/P 2 has been set to be turned on by Zone 3
 O/P 3 has been set to be turned on by the Loop I/P Loop 1 Address 12 Input 2.
Again click on “Change” to set the output.
Note: The following screen is for demonstration purposes only as only on 1 drop down box will
appear at any one time as will the “Edit Input” selection box. Note also that the SmartTerminal has
not been selected in the Controller Edit Module Types screen hence it tab is not displayed at the top
of the screen.
Figure 36: The Edit Internal Serial Screen
Figure 37: Edit Input - Group Settings and Sensor Settings