Specifications

Page 53
FIREFINDER SERIES II INSTALLATION, COMMISSIONING &
OPERATION
7 FireFinder Control Panel
MENU
FUNCTION
POWER ON
PRE-ALARM
TEST MODE
SOUNDER STATUS
SUPPLY FAULT
FIRE
ZONE
SENSOR
LOOP
DISPLAY
TO
1
4
7
ABC
JKL
TUV
2
5
8
0
DEF
MNO
WXYZ
SPACE
ENTER
3
6
9
GHI
PQRS
SYMB
DEVICE
DISABLE/ENABLE
SOUNDER
SILENCE
EVACUATE
PREVIOUS
NEXT
BUZZER
SILENCE
RESET
INDICATOR
TEST
FAULT
DISABLED
'2'
LCD WINDOW
CANCEL ENTRY
EARTH FAULT
SYSTEM FAULT
F.W.R.E. ACTIVE
F.A.R.E. ACTIVE
F.W.R.E. FAULT
F.A.R.E. FAULT
Figure 58: The FireFinder Control Panel with an 8 Line LCD
Controls & Indicators
FIRE
(Red): This LED will be illuminated steady if any fire alarms are present on the system.
FAULT
(Yellow): This LED will be illuminated steady if there are any faults on the system,
whether they are loop faults, module faults, device faults etc.
DISABLED
(Yellow): The LED will light steady if any detectors, devices or zones in the system
have been disabled or if an output relay has been de-activated. The display will show the conditions
as per EN54 9.2 and 9.4.2
SOUNDER
SILENCE
(Yellow): Pressing this button will silence any Bells or Sounders (activated either by a
fire alarm, a manual evacuation or a manual alert) that are connected to the fire panel. If the bells or
sounders are silenced the LED just above the button will be illuminated steady indicating that the
sounders have been silenced and a sounder resound is available. If a manual evacuate or manual
alert condition is present when the Sounder Silence button is pressed, these conditions will remain
visible indicating the conditions are still present for resounding. A new Fire Alarm, manual evacuate
or manual alert will resound all the previously silenced Bells and Sounders. Pressing Sounder
Silence a second time while the Sounder Silence LED is illuminated, will also re-sound the Bells and
Sounders.
EVACUATE
(Yellow): Pressing this button will activate the Sounders and Bells that have been
programmed for manual evacuation and the LED just above the button will be illuminated steady. If
the sounders have been previously silenced the LED above the Sounder Silence button will turn off
and the Sounders and Bells that were previously silenced will resound. This manual evacuate
condition can only be cleared by a Reset and will override a manual “Alert” condition.