Owners manual

www.amp-research.com
11/12
IM75101 rev 01.31.18
AMP RESEARCH POWERSTEP
TM
– DODGE RAM
Drill a 9/32” hole through the pinch weld at marked
locations. Debur all holes.
Insert grommet into drilled holes. Insert lamp wires
through the grommets.
Afx lamp to rocker panel surface. Make sure lamp
is afxed to a at, clean surface.
20
Using supplied butt connectors, connect the lamp
wires. Red to Red, Black to Black. Once Crimped
use heat gun to shrink tube.
Close and wrap with conduit and electrical tape.
Secure all loose wires with cable ties, with lamp
wires pulled upward to avoid any wire snagging.
18
19
18
32
33
34 35
36 37
Reinstall fuse.