Owners manual

rev 07.10.18
3/6
www.amp-research.com
AMP RESEARCH BEDXTENDER HD™
UNIVERSAL MOUNTING BRACKET INSTALLATION
2
3
Following instructions
on the supplied drill
templates, align
templates as shown,
with top edge parallel
to truck bed rail,
afxing with tape.
Drill at 3 indentations
created in Step 2.
3
1
Rest lower edge on
lower tailgate bumper.
RAM Bed Extender - Drill Template
Driver Side
Mark all three hole locations
with center punch and then
drill hole size to 5/32” (4mm)
CAUTION: Make sure center punch
indentations are deep enough to prevent the drill bit from wandering. Misdrilled holes may adversely aect installation of brackets.
BEND DOWN 90°
BEND UP 90°
TAPE
TAPE
TAPE
CAUTION: Make sure center punch indentations are deep enough to prevent the drill bit from wandering. Misdrilled holes may adversely aect installation of brackets.
BEND DOWN 90°
BEND UP 90°
RAM Bed Extender - Drill Template
Passenger Side
TAPE
TAPE
Rest lower edge on
lower tailgate bumper.
Mark all three hole locations
with center punch and then
drill hole size to 5/32” (4mm)
TAPE
Use center punch to rmly mark drill locations as
indicated on templates.
2
4
Left side shown, opening in
bracket faces Back of vehicle.