Owners manual
rev 07.10.18
2/6
www.amp-research.com
AMP RESEARCH BEDXTENDER HD™
11
PARTS LIST AND HARDWARE IDENTIFICATION
Quick Mount
Bracket Set
1
x2
Phillips head
screw
(included in 74608-01A)
2
x6
x4
4
Bumper
9
Double Bend Center Tube (With AMP Logo)
3
PT-Screw
x12
x2
x2
5
Strap Buckle Assembly
Double Bend Center Tube (Without AMP Logo)
10
6
x2
Pivot Upright Assembly
7
x2
Bumper Upright Outer
8
x2
Bumper Upright Inner
Rest lower edge on
lower tailgate bumper.
RAM Bed Extender - Drill Template
Driver Side
Mark all three hole locations
with center punch and then
drill hole size to 5/32” (4mm)
CAUTION: Make sure center punch
indentations are deep enough to
prevent the drill bit from wandering.
Misdrilled holes may adversely aect
installation of brackets.
BEND DOWN 90°
BEND UP 90°
TAPE
TAPE
TAPE
CAUTION: Make sure center punch
indentations are deep enough to
prevent the drill bit from wandering.
Misdrilled holes may adversely aect
installation of brackets.
BEND DOWN 90°
BEND UP 90°
RAM Bed Extender - Drill Template
Passenger Side
TAPE
TAPE
Rest lower edge on
lower tailgate bumper.
Mark all three hole locations
with center punch and then
drill hole size to 5/32” (4mm)
TAPE
Drill Templates