User Manual

www.amp-research.com
8/9
IM76151 rev 05.04.16
A M P R E S E A R C H P O W E R S T E P
T M
– F O R D F - 1 5 0
www.amp-research.com
8/9
Attach step, sliding the mounting T-nut into
position. Torque to 10 ft lbs (13.5 Nm)
On each side of the vehicle measure from the
rear linkage to end of the board. Measurement
should be approximately 11” as shown below.
16
15
Mark hole location 1/2” midpoint of the rocker
with tape and center punch and drill 19/64” hole
into pinch weld. Deburr hole and insert grommet
(#16) for LED Wire.
Route LED wires though through grommet,
clean surface, and stick on to rocker panel as
shown below.
On each side of the vehicle use tape to mark the led drill location two sections from studs as
shown below. Use tape to indicate. Locations are approximately 22” & 66” from front door edge.
Drive Side Rear Mounted
(In between two rivets just forward of
mounting location, as shown above)
Drive Side Front Mounted
(Just under left edge of body-
brace, as shown above)
1 3
4
9
7
8
5
6
2
10
11
18
20
19
12
13
14
15
16