User Manual

www.amp-research.com
6/9
IM76151 rev 05.04.16
A M P R E S E A R C H P O W E R S T E P
T M
– F O R D F - 1 5 0
On Supercrew
models, remove
grommet in floor
panel above front
linkage on driver
side. Poke small
hole into grommet
and thread the two
trigger wires through
and up into the cabin
of vehicle. Seal
grommet with silicone
sealer.
Route factory harness underneath vehicle and
plug in motors (both sides). Route remaining
LED light wires back towards rear of vehicle.
On Super Cab & Regular Cab models, use a
9/32” drill bit to drill hole through floor and insert
grommet (#11) that is supplied with kit. Thread
the wires through and apply silicone sealant.
POKE SMALL HOLE
THROUGH GROMMET
Connect red and black power leads to battery.
Red lead goes to positive. Route shorter leg of
harness down passenger-side wheel well and
longer leg of harness down along driver side
wheel well. Secure with tie wraps.
5
Attach wire harness to controller (make sure
connector locking tabs fully engage). Mount
controller with the two 11” tie wraps to factory
conduit, just forward of battery.
4
Remove fuse from wire harness
5
Remove driver side front kick panel and door
sill plate. Roll back carpet to access hole for
passing trigger wires into cab of vehicle.
11
4
10
6
7
5
16
8
10
16
9