User Manual

www.amp-research.com
5/9
IM76151 rev 05.04.16
A M P R E S E A R C H P O W E R S T E P
T M
– F O R D F - 1 5 0
Locate mounting points; first and last set of studs on the inner sill.
Motor Linkage mounts toward the front of the truck and Idller mount toward the rear. Driver side
shown below.
Mount drive and Idler linkage assemblies. Repeat for passenger side. Make sure linkages sit
square, fully resting on studs before tightening. Torque to 16 ft. lbs (22Nm)
Relocate Brake Cable Guide as shown in following steps.
Driver Side Front Stud Location
Driver Side Rear Stud Location
Drive Linkage (Front)
Idler Linkage (Rear)
A. Remove bolt with 13mm box
wrench or socket.
B. Remove and relocate J-Clip
to location shown above. Bend
bracket tab flat to reinstall.
C. New location of Brake Cable
Guide installed shown above.
New Mount
Location
Bend Tab
1
2
4
3