Installation Manual

www.amp-research.com

3/3

IM75403 rev 03.31.16

To retract, gently kick up on the underside of the

step pad.

To deploy the step, press down using your foot on

the outside edge of the step pad.

For all other Models: Using 19mm socket, tighten bolt

to 35 ft-lbs. Tighten M8 screw from step 9 to 16 ft-lbs.

For all other Models : Attach bracket to threaded hole

in frame mount. Rotate bracket into position and use

the provided M12 hardware.

NOTE: If a hole is not provided on a factory body

mount, a hole must be drilled using a 1/2” drill bit.

For 2011 - up Short bed models: Attach bracket to

threaded hole in frame mount. Rotate bracket up to

position and use provided M12 Hardware. Tighten M8

bolt to 16 ft-lbs and M12 bolt to 35 ft-lbs.

For 2011 - up Short bed models: Remove the two

rearmost u clips off the bracket and change orienta-

tion of the bolt so that the bolt head is on the outside

of the bracket. Torque bolts to 16 ft-lbs.

13mm &

19mm

13mm &

19mm