Installation Manual

www.amp-research.com

2/3

IM75403 rev 03.31.16

15mm

Using a 15mm socket with extension, align bolt with

threaded plate. Torque to 20 ft-lbs.

Using a 15mm socket with extension, align bolt with

threaded plate. Do not tighten.

15mm

Locate forward most bed channel. Insert Threaded

Plate into Bed Channel. Jog in bracket must match

jog in Bed Channel. (Driver Side Shown)

Torque bolts from Steps 3 and 5 to 20 ft-lbs.

15mm

For 2011 - up Short bed models: Using a 15mm sock-

et remove four bolts holding factory bracket in place.

The two rear most U clips will need to be removed in

step 10. For all other models skip to step 10.

Locate the step pad on the center position of the

lower linkage assembly and secure using provided

PT Screws. Tighten to 5 ft-lbs using T25 Torx bit.

Align Step pad to be in line with fender.

T25 Torx

FRONT