Installation Manual

www.amp-research.com

8/12

IM75154 rev 02.24.15

A M P R E S E A R C H P O W E R S T E P

T M

– C H E V R O L E T / G M C

Inser t

Tighten

Strip 3/8”

Insert and

Tighten

Posi-Tap™ instructions

Tape red wire to (grey with black wire on driver side

and tan with white stripe on passenger side). Pull

trigger wire out and remove red wire. Next run trig-

ger wire thru rubber accordian. Save red wire for rear

doors.

Route trigger wire into the door. Poke hole through

rubber grommet and push wire through. Pull back

door weather guard and run wire across door panel

to door switch plug.

Using supplied Posi-Tap connector connect trigger

wire on harness (Driver Side: Grey/Black Stripe &

Passenger Side: Tan/White Stripe) to Solid dark grey

wire on door switch plug. Passenger side shares the

same color wire. Note:Wire is located in the upper

outer pin of plug. (Left on Driver, Right on Pas-

senger Side)

Remove seal on door panel by removing metal clips

that attach it to panel with a flat screwdriver.

Attach clips to grooves in door.

Driver Door shown