Installation Manual

www.amp-research.com

6/12

IM75154 rev 02.24.15

A M P R E S E A R C H P O W E R S T E P

T M

– C H E V R O L E T / G M C

Route long end of wire harness above engine and

down through drivers side wheel well. Zip tie harness

to cowling clips on fire wall. Route short end down

passengers side.

Pull up the carpet and drill 9/32” hole in metal and

insert supplied rubber grommet

NOTE: Seal holes

with silicone glue

and cover with tape

so carpet does not

stick to glue.

Route wire harness along the frame and back towards

rear linkage. Secure with zip ties. Push both wires

through rubber grommets. Connect harness to motor.

Secure harness with tie wraps.

Pull up front door sill plate covers as shown.

FRONT DOOR WIRING: Pop cover plate off. Work

your way across the bottom of cover. Once bottom is

poped loose pull down and out.

Remove Front door Cover plates behind door handle

and in bottom of grab handle to access mounting

FRONT DOOR WIRING: Steps 13-30 are for front doors