Installation Manual

www.amp-research.com
10/12
IM75154 rev 02.24.15
A M P R E S E A R C H P O W E R S T E P
T M
– C H E V R O L E T / G M C
Use supplied red wire and feed through accordian
and into door panel.
Using a 7mm socket remove the 4 screws that secure
the rear door panel in place.
Remove Rear door Cover plates behind door handle
and in bottom of grab handle to access mounting
screws.
Once panel pins are out lift up on panel. Lift panel up
and off of door.
2
1
1
2
3
3
Pry all panel fasteners loose. Start at door hing side
and work your way around the bottom and towards
latch side of door.
Feed wire to front sill area. Run wire between door
seal and black wire casing. Place wire under loom
and connect red wire to powerstep trigger wire (Light
blue and black stripe on driver side and Green with
a black stripe on passenger side)with supplied butt
connector. Once crimped use heat gun to shrink
tube.
30
31
32 33
34 35