Installation Manual

rev 04.22.16
5/7
www.amp-research.comwww.amp-research.com
A M P R E S E A R C H B E D X - T E N D E R ™
BED X-TENDER ASSEMBLY – CONTINUED
NOTE: The inside of the upright is stepped to fit correctly around the small and large diam-
eter tubes.
Tighten PT-Screws using a T-25 torx driver, starting in the middle of each upright, then the outer screws
and lastly the remaining two to evenly tighten.
7
8
NOTE: Do not over tighten as this may strip out. Fastener will reach a noticeable stopping
point.
Attach plastic upright around the tube juncture, placing rubber bumpers into the two ends of the upright.
3
7
6
3
7
6
Upright is not positioned
in center of tube joint.