Installation Manual

rev 04.22.16

4/7

www.amp-research.com

A M P R E S E A R C H B E D X T E N D E R H D ™

BED X-TENDER ASSEMBLY

Using template measure 7” from each end of the

three long tubes and mark with tape. Tape is to be

used as a reference point. (See step 6)

Repeat for the other side.

Adjust the width of the BEDXTENDER to fit the pre-

installed mounting brackets. To keep tube overlap

constant, adjust each tube so that the gap between

the edge and the tape is the same.

5 6

7” MEASURING TOOL

Slide the center tube into the center tube of the 3-

tube assembly. Be sure to slide on Strap Buckle

Assembly to center tube of Pivot Upright Assem-

bly

Insert the top long tube into the top tube of the 3-tube

assembly.

Insert the bottom long tube into the bottom tube of

the 3-tube assembly.

Note: Install Strap Buckle Assembly to cen-

ter tube of Pivot Upright Assembly.

Note: Tubes do not need to

be pushed in to taped edge.

Note: If tube joints are tight Soapy

Water can be used.

Note: Template

located on inside

of box.