Installation Manual

rev 04.22.16
3/7
www.amp-research.com
A M P R E S E A R C H B E D X T E N D E R H D ™
1
2
Remove the 2 Phillips screws that are holding
the tail lights in place. Carefully pull back to
remove tail lights.
Tape template to vehicle to locate upper hole
oMounting Bracket. Mark (Center Punch) &
drill hole with 1/8” drill bit. Remove template
and drill out hole with 21/64” drill bit. Use file
to remove burrs. Apply primer to edge of hole.
Repeat for other side.
Place Mounting Bracket aligned with top hole. Allow
bracket to hang vertically. Mark (Center Punch) loca-
tion of lower hole using the bracket slot as a template.
Remove bracket. Drill hole with 1/8” drill bit then drill
out hole with 21/64” drill bit. Use file to remove burrs.
Apply primer to edge of hole. Allow primer to dry.
Assemble Mounting Bracket using the M8 bolts & nuts
as shown. Tighten & torque to 22ft. lbs. Replace the
tail light assembly. Repeat for other side.
MOUNTING BRACKET INSTALLATION - CHEVROLET COLORADO / GMC CANYON 2015
PLEASE READ ENTIRE INSTRUCTIONS BEFORE PROCEEDING WITH INSTALLATION
2X
Quick Mount Bracket
Center over Tailgate
Anchor Bolt
Chevy Colorado
GMC Canyon
Bed Extender Drill Template
TAPE
TAPE
TAPE
TAPE
PASSENGER
Use center punch,
pilot drill (1/8”), then
drill final hole size (21/64”)
BEND UP 62°
BEND DOWN 65°
Chevy Colorado
GMC Canyon
Bed Extender Drill Template
TAPE
TAPE
TAPE
TAPE
PASSENGER
Use center punch,
pilot drill (1/8”), then
drill final hole size (21/64”)
BEND UP 62°
BEND DOWN 65°
Center over Tailgate
Anchor Bolt