Installation Manual

rev 07.02.14
4/8
www.amp-research.com
A M P R E S E A R C H B E D X T E N D E R H D ™
UNIVERSAL MOUNTING BRACKET INSTALLATION
Cut out supplied template and tape to the
D-pillar as shown. Using a center punch, mark
holes as specified by the template.
Using a power drill and 9/64” drill bit, drill
through the sheet metal. If equipped with a
bedliner, drill through bedliner.
Fasten mounting brackets using the supplied
self-tapping Phillips screws and torque to 30 in.
lbs. If equipped with a bedliner, install mounting
brackets over bedliner.
NOTE: If bedliner has contours that may prohibit
a flat, solid mounting surface, cut out a rectan-
gular section to clear the bracket and mount the
bracket directly to the metal D-pillar.
2
1
Phillips head
screw
2
x6
2
1
2
3
Quick Mount
Bracket
1
x2