User Manual

rev 07.02.14
6/8
www.amp-research.com
A M P R E S E A R C H B E D X T E N D E R H D ™
BED X-TENDER ASSEMBLY – CONTINUED
Adjust Strap Buckles to lock into the tailgate when BEDXTENDER is deployed.
Your assembly is now complete.
7
9
8
Tighten PT-Screws using a T-25 torx driver, starting
in the middle of each upright, then the outer screws
and lastly the remaining two to evenly tighten.
3
8
7
NOTE: Do not over tighten as this may strip out.
Fastener will reach a noticable stopping point.
8
Attach plastic upright around the tube juncture, plac-
ing rubber bumpers into the two ends of the upright.
NOTE: The inside of the upright is stepped
to fit correctly around the small and large
diameter tubes.
4
8
7
Upright is not positioned in
center of tube joint.