Data Sheet

www.ampedrftech.com

(A)

If using a permanently affixed label, the modular transmitter must be labeled with its own FCC

identification number, and, if the FCC identification number is not visible when the module is installed inside

another device, then the outside of the device into which the module is installed must also display a label

referring to the enclosed module. This exterior label can use wording such as the following: “Contains

Transmitter Module FCC ID: X3ZBLEMOD1” or “Contains FCC ID: X3ZBLEMOD1.”

(B)

If the modular transmitter uses an electronic display of the FCC identification number, the

information must be readily accessible and visible on the modular transmitter or on the device in which it is

installed. If the module is installed inside another device, then the outside of the device into which the

module is installed must display a label referring to the enclosed module. This exterior label can use

wording such as the following: “Contains FCC certified transmitter module(s).”

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to

part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions, may cause harmful interference to

radio communications. However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged to try to correct the interference by

one or more of the following measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

—Consult the dealer or an experienced radio/TV technician for help.

Industry Canada statement:

Label of the end product:

The final product must be labeled in a visible area with the following "Contains transmitter module IC: 8828A-

BLE1"

This Class B digital apparatus complies with Canadian ICES-003.

Cetappareilnumérique de la classe B estconforme à la norme NMB-003 du Canada.

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and

Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:

(1)

This device may not cause interference; and

(2)

This device must accept any interference, including interference that may cause undesired operation of the

device.

L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation,

Sciences et Développement économique Canada applicables aux appareils radio exempts de licence.

L’exploitation est autorisée aux deux conditions suivantes :