Data Sheet

www.ampedrftech.com
14
3.5.1. Reference Design with INT LPO
Notes: The LPO pin should be left floating; do not ground.
4. Regulatory Compliance
Federal Communications Commission statement:
This module has been tested and found to comply with the FCC Part15.
These limits are designed to provide reasonable protection against harmful interference in approved
installations. This equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Modifications or changes to this equipment not expressly approved by Amp’ed RF Technology may void the
user’s authority to operate this equipment.
The modular transmitter must be equipped with either a permanently affixed label or must be capable of
electronically displaying its FCC identification number