User's Manual

Phone: [phone] | E-mail: [e-mail]
Address : 2674 N. First Street, ste 220, San Jose, CA 95134
电话：[phone] | 传真：[phone] 转 111 | E-mail: [e-mail]
地址：天津市华苑产业区海泰西路 18 号西 3B-202（300384）
16
4 Regulatory Compliance
Federal Communications Commission statement:
This module has been tested and found to comply with the FCC Part15.
These limits are designed to provide reasonable protection against harmful interference in
approved installations. This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a
particular installation.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Modifications or changes to this equipment not expressly approved by Amp’ed RF Technology
may void the user’s authority to operate this equipment.
The modular transmitter must be equipped with either a permanently affixed label or must be
capable of electronically displaying its FCC identification number
(A) If using a permanently affixed label, the modular transmitter must be labeled with its own FCC
identification number, and, if the FCC identification number is not visible when the module is
installed inside another device, then the outside of the device into which the module is installed
must also display a label referring to the enclosed module. This exterior label can use wording
such as the following: “Contains Transmitter Module FCC ID: X3ZWFMOD9” or “Contains FCC ID:
X3ZWFMOD9.”
(B) If the modular transmitter uses an electronic display of the FCC identification number, the
information must be readily accessible and visible on the modular transmitter or on the device in
which it is installed. If the module is installed inside another device, then the outside of the device
into which the module is installed must display a label referring to the enclosed module. This
exterior label can use wording such as the following: “Contains FCC certified transmitter
module(s).”
To satisfy FCC RF Exposure requirements for mobile and base station transmission devices, a
separation distance of 20 cm or more should be maintained between the antenna of this device
and persons during operation. To ensure compliance, operation at closer than this distance is not
recommended. The antenna(s) used for this transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.