User's Manual

Phone: [phone] | Fax: [phone] | E-mail: [e-mail]
Address : 1879 Lundy Ave, ste. 138, San Jose, CA 95131
电话：[phone] | 传真：[phone] 转 111 | E-mail: [e-mail]
地址：天津市华苑产业区海泰西路 18 号西 3B-202（300384）
14
(A) If using a permanently affixed label, the modular transmitter must be labeled with its own FCC
identification number, and, if the FCC identification number is not visible when the module is
installed inside another device, then the outside of the device into which the module is installed
must also display a label referring to the enclosed module. This exterior label can use wording
such as the following: “Contains Transmitter Module FCC ID: X3ZBTMOD8” or “Contains FCC ID:
X3ZBTMOD8.”
(B) If the modular transmitter uses an electronic display of the FCC identification number, the
information must be readily accessible and visible on the modular transmitter or on the device in
which it is installed. If the module is installed inside another device, then the outside of the device
into which the module is installed must display a label referring to the enclosed module. This
exterior label can use wording such as the following: “Contains FCC certified transmitter
module(s).”
To satisfy FCC RF Exposure requirements for mobile and base station transmission devices, a
separation distance of 20 cm or more should be maintained between the antenna of this device
and persons during operation. To ensure compliance, operation at closer than this distance is not
recommended. The antenna(s) used for this transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
5.1 Modular Approval, FCC and IC
FCC ID: X3ZBTMOD8
IC: 8828A-MOD8
In accordance with FCC Part 15, the BT53 is listed above as a Modular Transmitter device.
5.2 FCC Label Instructions
The outside of final products that contain a BT53 device must display a label referring to the
enclosed module. This exterior label can use wording such as the following:
Contains Transmitter Module
FCC ID: X3ZBTMOD8
IC: 8828A-MOD8
Any similar wording that expresses the same meaning may be used.