User's Manual

Phone: [phone] | Fax: [phone] | E-mail: [e-mail]
Address : 1879 Lundy Ave, ste. 138, San Jose, CA 95131
电话：[phone] | 传真：[phone] 转 111 | E-mail: [e-mail]
地址：天津市华苑产业区海泰西路 18 号西 3B-202（300384）
13
5 Regulatory Compliance
This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry Canada.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Cet dispositif est conforme à la norme CNR-210 d'Industrie Canada applicable aux appareils radio
exempts de licence. Son fonctionnement est sujet aux deux conditions suivantes:
(1) le dispositif ne doit pas produire de brouillage préjudiciable, et (2) ce dispositif doit accepter
tout brouillage reçu, y compris un brouillage susceptible susceptible de provoquer fonctionnment
indésirable.
The radiated output power of the device is far below the FCC radio frequency exposure limits.
Nevertheless, the device shall be used in such a manner that the potential for human contact
during normal operation is minimized.
Modifications or changes to this equipment not expressly approved by Amp’ed RF Technology
may void the user’s authority to operate this equipment.
This Class B digital apparatus complies with Canadian ICES-003.
Cetappareilnumérique de la classe B estconforme à la norme NMB-003 du Canada.
The modular transmitter must be equipped with either a permanently affixed label or must be
capable of electronically displaying its FCC identification number
(A) If using a permanently affixed label, the modular transmitter must be labeled with its own FCC
identification number, and, if the FCC identification number is not visible when the module is
installed inside another device, then the outside of the device into which the module is installed
must also display a label referring to the enclosed module. This exterior label can use wording
such as the following: “Contains Transmitter Module FCC ID: X3ZBTMOD7” or “Contains FCC ID:
X3ZBTMOD7.”
(B) If the modular transmitter uses an electronic display of the FCC identification number, the
information must be readily accessible and visible on the modular transmitter or on the device in
which it is installed. If the module is installed inside another device, then the outside of the device
into which the module is installed must display a label referring to the enclosed module. This