User's Manual

interference in approved installations. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. This
device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause
undesired operation.
Modifications or changes to this equipment not expressly approved by Amp’ed RF
Technology Inc. may void the user’s authority to operate this equipment.
III. Limited Modular Approval
FCC ID: X3ZBTMOD2
In accordance with FCC Part 15, the BT23 is listed above as a Limited Modular
Transmitter device.
In support of the Modular Transmitter Approval, the following is stated:
1. The module does have buffered modulation / data inputs.
2. The module does regulate its own power supply.
3. The module does have a permanently attached antenna.
4. The module can be tested as a stand-alone device.
5. The module is labeled with the proper FCC ID, and labeling instructions are
provided to OEM end users for external product labels.
6. The module does have instruction for proper use.
7. The module does meet the FCC RF regulations.
Limited Modular Transmitter Approval, is requested, instead of Modular Transmitter
Approval, because the following condition is not met:
1. The module does not have its own RF shielding.