Instruction Manual

• We advise our customers to have the ACCM fitted by a professional.
• Never remove the cover of the
ACCM or ACCM+ .
• Before you install the individual components, check that the installation area has been selected in
such a way that:
• The cable length is sufficient to connect later on every element: power cable and antenna (if
necessary)
• for a car equipped with a keyless start system, the location where you plan to install the ACCM must
be within the reception area of the keyless system of the car. Use therefore the original key and place it at the
chosen installation area and check immediately that the engine can be started.
• Do not install any component in the airbag deployment area.
• Do not install the
ACCM or ACCM+ against a large metal surface in the car.
• Once the installation is completed, make sure that no cables are pinched or trapped.
• In case you would like to buy additional keys and have them programmed to the vehicle’s
immobilizer system in the future, some manufacturers require that all original keys are present in the car to be
able to get an additional key. It will be necessary that you participate in the coding of the new key with a
virtual key being active and connected to the car to perform the actions required by the dealer.
• OTA keys is not responsible for the damage caused to the vehicle and/or accessories with are the
results of a non-respect of the instructions of this manual.
IMPORTANT REMARKS
• Placing the
ACCM or ACCM+ under or next to any large metal surface or an airbag could
affect the reception of the ACCM.
• With the keyless start system, the vehicle doors can be opened without need for the
driver to physically push a button on the key fob to lock or unlock the doors. To start or to stop the
engine, there is no need to insert a key in the barrel to turn on the ignition.
• Installation steps 1 and 2 (see below) must only be performed for cars not equipped with
a keyless start system. If the car is equipped with a keyless system, go directly to step 3.
INSTALLATION STEPS:
Disconnect the battery of the car.
1. Disassemble the shroud for easy access to the vehicle’s ignition switch. Pull the steering
wheel in your direction to its maximum.
2. Place the ring of the antenna around the vehicle’s ignition switch as shown below.
Fix and tape the ring around the ignition, excess cable can be taped together but may not
be turned around (one rotation maximum). When using the ring method for installing the
ACCM or ACCM+ , the ring MUST be taped in front of the factory receiver ring. It CAN NOT
be on top of, or behind the factory receiver ring. See illustration above. The antenna cable
must follow existing steering column cables to avoid rupture while closing the shroud or
moving the steering wheel.
Reassemble the shroud.
+
-
WARNING
OTA keys S.A and its affiliates should not be held liable towards end-users for third parties prejudice caused by misusage of the
product. We advise our customers to have the ACCM fitted by a professional.