User manual

1. Uninstall the bottom terminal cover.
2. Place the machine face down on a flat table with soft cushion.
3. Disconnect all connectors from the machine.
4. Unscrew the four screws locking the stand, and remove the stand.(See picture 1)
5. Reconnect all connectors that were disconnected in step 2.
6. Cushion the four wall mount screw holes on the rear cover with two pads each.(You can find 8 cushion
pads in the accessories)
7. Now you can start to assemble the wall mount following instructions in the wall mount user guide.
8. Lock the wall mount bracket onto the rear cover of the machine using proper screws, making sure the
screwed depth is no less than 10mm and no more than 15mm.
9.Assemble the terminal cover onto the machine. The signal line can be fetched out either from the top or
bottom opening.
Assemble the wall mount
Only those wall mounts whose bearing capacity exceeds 150KG with a hole distance of
400(H)*200(V) and with not less than 4 M6 holes are applicable to this LCD TV.
Before getting started with the wall mount, you need to firstly disassemble the stand by
following the steps below.
①②
③
-10-