Owner manual

Important: Always read and follow operating instructions. • 7
Attach switch magnets to the upper strut bracket
using the plastic screw and steel nut as shown. Do not
tighten nut.
Drill 7/8-inch diameter hole at location shown for
emergency stop switch. Attach STOP decal to hood
with decal hole centered over the hole in the hood.
Feed the stop switch wire from outside hood through
the round stop decal and hole in the hood. Slide the
switch nut over the wire and tighten to the back of the
switch. Route the wire and tighten to the back of the
switch. Route the wire along the hood tube as shown
and secure with cable ties (marked with an *).
940111 Kit Only
940111 & 95000223 Kits Only
940111 &
95000223
Kits Only