Owner's manual

4 • AMMCO Drum & Disc Brake Lathes
Principal Operating Parts
Know Your Unit
Compare this illustration with the unit before placing it into service. Maximum performance and safety will be
obtained only when all persons using the unit are fully trained in its parts and operation. Each user should learn
the function and location, of all controls.
Prevent accidents and injuries by ensuring the unit is properly installed, operated and maintained.
Control Console
 Rotor Rough Cut – press to activate.
 Rotor Finish Cut – press to activate.
 Rotor Start/Stop – press to start or stop feed.
 - (Minus) – press to decrease feed rate value dis-
played.
 Feed Rate Display – indicates the value selected for
rough and finish feed rates.
 + (Plus) – – press to increase the feed rate value
displayed.
 Spindle Jog – moves the spindle in the direction
indicated. Only active in drum mode.
 Drum Rough Cut – press to activate.
 Drum Finish Cut – press to activate.
 Drum Start/Stop – press to start or stop feed.
4100E Brake Lathe
 Control Console
 Grease Fitting
 Cross Feed Gearbox
 Oil Dipstick
 Drive Motor Pulley Guard
 Drum Feed Gearbox Assembly
 Draw Bar
 Twin Cutter
 Work Light
 Spindle Arbor
 Spindle Lock Knob
 Cross Feed Handwheel
 Feed Lever
 Cross Feed Lock
 Cross Feed Lock Knob
 Spindle Speed Adjusting Lever
 Power Cord
 ON/OFF Switch
 Boring Bar and Boring Clamp










8 8