Installation Guide

5
1.
X1
X8
X8
-Put the wall profile 6FR09 and small wall jamb
6FR01 against the wall and ensure they are
vertical
by spirit level.
-Drill the holes(φ6mm)accordingly.
-Insert wall plugs 6FR05(8x) into the holes.
-Fasten the wall profile and wall jamb on the wall
with screws 6FR04(4x).
6FR04
6FR05
ST4.0x30
6FR01 6FR09
X1
2.
-Apply the silicone sealant to the inside of the top and bottom pivot
6FR17 and 6FR19,
-Lay the front panel 6FR08 on foam blocks, mount the pivots on the top
and bottom of panel by using the tube 6FR29 as shown below .
X1
X1
X1
6FR17
6FR29
6FR19
6FR08
X1
Top pivot
Bottom pivot
NOTE: The top pivot and top pivot bracket is flat without any
cam. The bottom pivot and bottom bracket have cams. Please
do not mix them together.
6FR01
6FR04
6FR05
6FR04
6FR09
6FR19
6FR17
6FR08