User Manual

CONNEX
TM
User Guide
39
Upgrading the Air Unit or Ground Unit
Firmware
Upgrading the Air Unit or Ground Unit firmware does not affect the settings of the wireless
video downlink.
 To upgrade the Air Unit or Ground Unit firmware:
1 Make sure that the computer on which the CONNEX Management application is installed
is connected to the Internet and is connected to the Air Unit/Ground Unit via a Micro
USB cable.
2 Launch the CONNEX Management application by double-clicking its desktop icon. The
following shows the window displayed on the Air Unit (on the left) and on the Ground
Unit (on the right). The Software Upgrade tab is selected by default. This is the only
tab that appears for the Ground Unit.
Figure 38: Upgrading the Air Unit (shown on left) or Ground Unit (shown on right)
The following describes the options in this window:
 Module: Specifies whether the connected unit is an Air Unit (Tx) or a Ground Unit
(Rx).
 SW Version: Specifies the version of the firmware currently installed on the unit.
 SN / MAC ID: Specifies the unique identifiers of this unit: Serial number and MAC
ID.
 Upgrade Button: The application automatically verifies with Amimon servers
whether the latest firmware version of the connected unit is already installed. If the
latest version is not installed, then the Upgrade button is active.