User Manual

CONNEX
TM
User Guide
36
Chapter 4, CONNEX
TM
Management Application
This chapter describes how to configure and upgrade the CONNEX Air Unit and Ground
Unit.
Overview
The Air Unit and the Ground Unit come preconfigured to communicate with each other. If
needed, you can reconfigure the wireless video datalink by connecting the Air Unit to a PC
and using the CONNEX Management application, as described in the Configuring the Link
section on page 41.
The Air Unit and the Ground Unit come preinstalled with the latest firmware version. If
needed, you can upgrade the firmware of each, as described in the Upgrading the Air Unit
or Ground Unit Firmware section on page 39.
 To use the CONNEX Management application:
1 Install the CONNEX Management application, as described in the Installing the CONNEX
Management Application section on page 37.
2 Connect the Air Unit or Ground Unit to a computer, as described in the Connecting the
Air Unit or Ground Unit to a Computer section on page 38.
Note: Only a single CONNEX Air Unit or CONNEX Ground Unit can be connected to the
CONNEX Management application at a time.