User Manual

CONNEX
TM
User Guide
21
Table 3: Air Unit – Power LED
On (White)
The Air Unit is powered on.
Off
No power is being supplied to the Air Unit.
Blinks
Quickly
Indicates a system error.
8 The Air Unit automatically connects with the powered on Ground Units that are paired
with this Air Unit.
A connection is established between the Air and Ground Units regardless of whether
video is transmitted on the wireless link, as follows:
 If video is transmitting, then the Ground Units display the video.
 If video is not transmitting, then the Ground Units display the message: Video signal
not detected upon linking to the Air Unit.
The Air Unit’s video and transmission status is indicated by its LEDs, as described below:
Table 4: Air Unit – Video LED
On (White)
The video signal from the camera is locked, meaning that it is being correctly
received by the Air Unit from the camera.
Off
The video from the camera is not locked, meaning that the Air Unit is not
receiving the video from the camera.
Blinks
Quickly
The Air Unit is powered down or the camera is transmitting a video resolution
that is not supported by the Air Unit.
Table 5: Air Unit – Network LED
On (White)
A link has been established to the Ground Unit, meaning that video is being
transmitted to it.
Off
The Air Unit is not broadcasting because it has not recognized any Ground
Units with which it was paired previously.
Blinks
Quickly
The Air Unit is pairing with a Ground Unit or the Air Unit has gone out of range
of the Ground Unit and is searching for it.
Blinks Slowly
The Air Unit is establishing a link with a Ground Unit.
Blinks Very
Slowly
The Air Unit is searching for an available frequency on which to transmit.
Note: This may take up to 70 seconds when working outdoors in Japan.
9 [Optional] To display information received from the aircraft’s flight controller overlaid on
the video on the Ground Unit monitor, you may refer to the Connecting the Telemetry
Port section on the following page.