User Manual

CONNEX
TM
User Guide
20
4 Connect the two Air Unit flat cable antennas to the two Air Unit cable antenna ports, as
shown below:
Figure 20: Connecting the Antennas to the Air Unit
5 Connect the provided Micro to Mini HDMI cable (Figure 5) from the HDMI IN port
on the Air Unit to the camera.
The right side of this cable (as shown in Figure 18) goes into the Air Unit HDMI IN port
(Figure 2).
The left side of this cable (as shown in Figure 18) goes into the aircraft’s camera.
Figure 21: Connecting the Air Unit HDMI Cable – Box 1A Micro to Mini HDMI
Close the HDMI Connector Screw (which is to the right of the HDMI IN port) to
stabilize the connected HDMI cable to the Air Unit.
6 Connect the provided Air Unit Power cable (Figure 8) to the power port on the Air
Unit.
The right side of this cable (as shown in Figure 22) goes into the Air Unit power port
labeled 8-26-VDC (Figure 2).
The left side of this cable (as shown in Figure 22) goes to the battery.
Figure 22: Connecting the Air Unit Power Cable – Box 1B
7 Connect the other end of the provided Air Unit power cable to the power source
(battery). Use an 8-26-VDC voltage battery.
Note that the Air Unit Power LED lights up. The following describes the various
states of the Air Unit Power LED: