User Manual

CONNEX

User Guide

 If attaching the Air Unit to a bar on the aircraft, then perform the following

before attaching the Air Unit to the mounting plate:

 A clear plastic holder is provided to help attach the mounting plate to a bar or to

the landing gear of the aircraft. The square plastic insert can be placed in the

opening in the center of the mounting plate either horizontally or vertically

according to how you want to position the mounting plate relative to the bar to

which you are attaching it.

 Insert the plastic holder into the opening in the square center of the mounting

plate, as shown below:

Figure 19: Connecting the Mounting Plate to a Bar on the Aircraft

2 Attach the mounting plate (with the Air Unit attached to it as described above) to the

aircraft using screws or plastic ties. Typically, it can be placed on the bottom of the

aircraft. Make sure that the Air Unit’s ventilation openings are not obstructed.

3 IMPORTANT! For optimal performance, carefully read and then implement the

guidelines provided in the

Placement Guidelines – Air Unit Cable Antennas

section on

page 22. These guidelines describe the best mounting options for the Air Unit cable

antenna options.

Attach the Air Unit cable antenna mounting accessories to the aircraft. Make sure the

mounting accessories are placed close enough to the Air Unit for the cable antennas to

reach the Air Unit antennas port.

Square plastic insert

for attaching the

mounting plate to a

bar