User Manual

CONNEX
TM
User Guide
15
Five Rx Antennas Connectors: The five provided antennas must be screwed onto these
connectors.
On/Off Switch: Set this switch to On in order to power on the Ground Unit.
OSD Button: Enables/disables the OSD display. The OSD display presents a screen of telemetry
MAVLink-based information collected by the CONNEX system on the monitor connected to the
Ground Unit, such as Air Unit flight parameters, height, direction, signal strength and so on. You
may refer to the Ground Unit – On Screen Display (OSD) section on page 28 for more information.
By default, OSD is enabled (displayed). Pressing this button disables OSD and pressing this button
again redisplays it.
Link Button: The CONNEX system supports up to four Ground Units per Air Unit. The Ground Unit
is provided out-of-the-box to automatically search for and connect to the Air Unit that is provided in
the same box. The Link button enables you to connect additional Ground Units to the same Air
Unit. You may refer to the Multicasting to Multiple Ground Units section on page 33 for a
description of this procedure.
HDMI Port: Enables the display of the received video. Connect this port to a monitor’s HDMI port
using the provided Standard HDMI cable.
Battery Plate Screws: Four screws are provided on the bottom of the Ground Unit for connecting
a battery plate. The battery plate is an optional accessory and is not included. It is available to be
purchased from the Amimon’s website.
For a description of the Air Unit LEDs, you may refer to:
 Table 6: Ground Unit – Power LED
 Table 7: Ground Unit – Video LED
 Table 8: Ground Unit – Network LED