User Manual

CONNEX
TM
User Guide
14
Ground Unit (Receiver)
The following shows both sides of the Ground Unit.
Figure 11: Ground Unit (Receiver) – 1
Figure 12: Ground Unit (Receiver) – 2
Table 2: Ground Unit Components
Tripod Mount Hole: Enables you to connect the Ground Unit to a tripod. Connection to a tripod is
optional.
Power Port: 7-17VDC voltage.
Micro USB Port: This port enables configuration and upgrade of the Ground Unit software using
the CONNEX Management application, as described in Chapter 4, CONNEXTM Management
Application section on page 36.
S.BUS Trainer: This port can be connected to the Futaba Remote Control trainer port. This port
enables you to remotely control the gimbal on the aircraft using the link between the Ground Unit
and the Air Unit. The bit rate of this control can be configured in the S.BUS Rate field using the
CONNEX Management application, as described in the Configuring the Link section on page 41.
Power Port
USB Port
S.BUS Trainer Port
Tripod Mount Hole
not in place
LEDs
Rx Antennas
ON/Off Switch
OSD Button
Link Button
HDMI Port