Installation lnstructions Surface Mount Consoles w w w . a m i c o .
Caution Console installation should conform to local building codes The installation instructions provided are for the Amico standard products. Slight modifications to the installations may be required. The product shipped to the job site may not be exactly as shown on the installation drawings. Before Installation 1. Review a copy of the final approved shop drawing(s) and/or submittal package.
Installation 1. Remove gas cover plates and devices by loosening any screws. Place everything in a safe and clean location.. 2. Remove the fascia by loosening the 2 screws (1 on each side) attaching it to the console. Place everything in a safe and clean location. www.amico.
3. Remove any aluminum device covers that are blocking access to the back plate. This is done by loosening the screws (typically 2 per cover) attaching it to the console box. Place everything in a safe and clean location. BACK PLATE EXISTING MOUNTING HOLES 4 4. Secure the console to the wall structure. Use existing holes if it matches the stud locations or drill new mounting holes as necessary (pictured above). Minimum two mounting locations should be used. 5.
www.amico.
www.amico.com Amico Pipeline | www.amico.com 85 Fulton Way, Richmond Hill Ontario, L4B 2N4, Canada 71 East Industry Court, Deer Park NY 11729, U.S.A Toll Free Tel: 1.877.264.2697 Toll Free Fax: 1.866.440.4986 Tel: 905.763.7778 Fax: 905.763.8587 Email: info@amico.
